Jewelry
Nickel-Free Jewellery: EU Rules and What to Tell Buyers
What EU law says about nickel, lead and cadmium in jewellery, what "nickel-free" can honestly mean, and how to put test and care details behind a QR code.
By Ali Murtaza ·

"Nickel-free" is one of the most searched phrases in jewellery, and one of the most loosely used. Nickel allergy is common, so buyers look for it, and sellers add it to listings and care cards. But EU law does not define "nickel-free". What it does set are hard limits on how much nickel a piece may release onto the skin, plus separate limits for lead and cadmium. This guide explains those rules, what you can honestly say about them, and how to give buyers the detail behind the claim. It is general information based on the regulations, not legal advice.
The EU nickel rule is a release limit, not a ban
Nickel is restricted under entry 27 of Annex XVII to the REACH Regulation (EC) No 1907/2006, in the wording set by Commission Regulation (EC) No 552/2009. The entry does not ban nickel in jewellery. It limits how fast nickel migrates out of the parts that touch the skin, measured in micrograms per square centimetre per week:
| Item | Limit in entry 27 | Where it comes from |
|---|---|---|
| Post assemblies inserted into pierced ears or other piercings | Nickel release must be less than 0.2 µg/cm²/week | Entry 27, paragraph 1(a) |
| Earrings, necklaces, bracelets, chains, anklets, finger rings, watch cases, watch straps and tighteners | Release from parts in direct and prolonged skin contact must not be greater than 0.5 µg/cm²/week | Entry 27, paragraph 1(b) |
| Those items when they have a non-nickel coating | The coating must keep release at or below 0.5 µg/cm²/week for at least two years of normal use | Entry 27, paragraph 1(c) |
| Placing on the market | Articles covered by paragraph 1 must not be placed on the market unless they conform | Entry 27, paragraph 2 |
| Testing | CEN standards are the test methods for showing conformity | Entry 27, paragraph 3 |
Two things follow. First, a piece can contain nickel, for example in a base metal under plating, and still be legal if it passes the release test. Second, plating matters: paragraph 1(c) asks that a coated piece keeps passing for at least two years of normal use, so a thin gold or rhodium layer over a nickel-bearing alloy needs testing that reflects wear, not just a fresh sample.
Lead and cadmium have their own limits
Nickel is not the only metal restricted in jewellery. Entry 63 of the same Annex XVII, added by Commission Regulation (EU) No 836/2012, says lead must not be placed on the market or used in any individual part of jewellery articles if its concentration is 0.05% by weight or more. "Jewellery articles" include imitation jewellery and hair accessories, with bracelets, necklaces, rings, piercing jewellery, wrist watches, brooches and cufflinks named. There are derogations, for example for crystal glass, enamels and untreated natural precious and semi-precious stones, under paragraph 4 of entry 63.
Entry 23 covers cadmium. Paragraph 10, added by Commission Regulation (EU) No 494/2011, sets a limit of 0.01% by weight of the metal in metal beads and other components for jewellery making, and in metal parts of jewellery, imitation jewellery and hair accessories. If you buy findings, chains or charms from suppliers, ask for test results covering all three metals, not just nickel.
What "nickel-free" can honestly mean
Because the law sets release limits rather than a definition, "nickel-free" on a listing is a marketing claim about composition. Under Article 6(1)(b) of the Unfair Commercial Practices Directive 2005/29/EC, a commercial practice is misleading if it contains false information, or is likely to deceive the average consumer, about main characteristics of the product such as its composition, and is likely to change their buying decision. So the words you use should match what you can show.
- "Nickel-free": only if the materials contain no added nickel and you have supplier declarations or tests to back it up. Some alloys contain trace nickel, so check before you print it.
- "Meets EU nickel release limits" or "tested to EU nickel release limits": a safer claim when you have a test report for the piece or batch, because it describes the legal standard you meet.
- "Hypoallergenic": avoid unless you can support it. No piece is safe for every allergy, and the regulation does not use the word.
- Material names: say "925 sterling silver", "surgical steel" or "gold-plated brass" plainly, and say what the plating sits on.
The care card is a good place to be specific. A short line such as "Base metal: brass. Plating: 18k gold, 2.5 microns. Tested to EU nickel release limits, report available" tells a sensitive buyer far more than a single badge.
Traceability: why batch numbers help here
The General Product Safety Regulation (EU) 2023/988 adds identification duties that fit neatly with test reports. Article 9(5) says manufacturers must make sure products bear a type, batch or serial number or other element that identifies the product, visible and legible for consumers, or, where the size or nature of the product does not allow it, give it on the packaging or an accompanying document. For small earrings or rings, that usually means the box or the care card. Article 9(6) asks for the manufacturer's name and postal and electronic address on the product, its packaging or an accompanying document, and Article 9(7) requires clear instructions and safety information where the product cannot be used safely without them.
For online shops, Article 19 says the offer must clearly show the manufacturer's details, information identifying the product including a picture and any product identifier, and any warning or safety information that goes on the product or packaging. A batch number that links your listing, your box and your test report makes all of this easier to keep consistent.
Put the detail behind a QR code on the care card
A care card has room for a few lines. A QR code on the card or box can hold the rest, and you can update it without reprinting when a supplier or plating changes. Useful things to put behind the code:
- Materials, base metal and plating thickness, in plain words
- Your nickel, lead and cadmium position, with the test date and the batch it covers
- Care steps that protect the plating, such as keeping pieces away from perfume, chlorine and sweat
- Sizing, repairs and re-plating options
- Your contact details and a route back to your shop for matching pieces
How Tapline fits
Tapline gives each piece or collection a story page behind its QR code, so materials, care and test details can sit on one page you update yourself. Tapline shows what you enter, so the claims and test reports stay your responsibility. Product passports give each category a structured page for the brand's own statement about materials and care.
If you want to tie a page to a batch, item-level codes give each unit a serial and batch and, with a GTIN, a GS1 Digital Link address. You can download the codes as SVG, PNG or ZIP for your card or box printer. Every plan shows scan counts per code. On the Growth plan and above you can add a reorder button that links to your own shop, email sign-ups are stored in Tapline, and multi-language pages are on the Scale plan for brands selling across EU markets. Klaviyo sync is coming soon.
See how jewellery and luxury brands use Tapline on the jewellery and luxury use case.
Read how a structured product page works on the digital product passport page.
Watch what a shopper sees when they scan one unit in the item page demo.
Related guides
- Jewelry QR codes and NFC tags: care cards and reorders
- QR code or NFC tag? /blog/qr-code-vs-nfc-tag
- Proof of authenticity for limited runs
- Free template: what to put behind your packaging QR code
- How to add a reorder button to packaging
FAQ
Is nickel banned in jewellery in the EU?
No. Entry 27 of REACH Annex XVII limits nickel release: less than 0.2 µg/cm²/week for piercing posts and no more than 0.5 µg/cm²/week for other items in prolonged skin contact.
Can I call my jewellery nickel-free?
Only if it is true and you can back it up. EU law does not define the term, and a false composition claim can be misleading under Article 6(1)(b) of Directive 2005/29/EC. "Tested to EU nickel release limits" is often more accurate.
Do plated pieces need extra care?
Yes. Under entry 27, paragraph 1(c), a coated piece must keep nickel release within the limit for at least two years of normal use, so test plated stock with wear in mind.
Where should the batch number go on small pieces?
Article 9(5) of Regulation (EU) 2023/988 allows the packaging or an accompanying document when the product is too small, so the box or care card is the usual place.